NuTech Floor Pro

NuTech Floor Sealing & Restoration provides grinding, honing and polishing of marble, travertine, limestone and granite floors, countertops and showers. Additional services include tile cleaning, grout cleaning, grout coloring and grout sealing. Located in Camarillo since 1988, we serve an area from West Los Angeles County to Goleta including: Malibu, Pacific Palisades, Santa Monica, Agoura Hills, Calabasas, Westlake Village, Thousand Oaks, Newbury Park, Simi Valley, Moorpark, Oxnard, Ventura, Ojai, Carpinteria, Montecito, Santa Barbara.


Grout Cleaning, Sealing and Coloring

Grout becomes dirty and worn with time. Heavy usage and improper cleaning procedures can contribute to premature sealant failure. NuTech Floor can thoroughly clean your grout and restore it to its original color. Then, a high-quality sealant is applied to help prevent staining and deep penetration of dirt, oils and other contaminates. Grout colorants can also be applied if you desire a change of color.



Stone Restoration

Stone gradually loses its luster and sheen. This can be caused from normal wear, improper cleaning procedures or excessive abuse. Areas with more use typically show more wear. Using the proper equipment, our experienced staff will bring back that glossy shine and color. Our company has been relied upon by discriminating homeowners from all over Ventura County, Santa Barbara County, LA County and beyond since 1988.





Stone Sealing

Sealing stone and grout is a vitally important step after a new installation, one that is sometimes overlooked. Failure to properly apply a high-quality sealant gradually affects the durability, appearance and feel of your stone surfaces. Since 1988, NuTech Floor has been providing resealing on a wide variety of stone and tile products including floors, countertops, showers, patios, kitchens, bathrooms and more.

	grinding This is the second stage in securing a flawless surface. This stage will remove all scratches from any de-lipped surface.

	Honing Honing: This is the third and sometimes last stage. At the hone stage, the surface is ~65% scratch free. There are several degrees of hone. All will leave the stone looking clean but aged.

	Polishing Polishing: This is the final stage, which leaves the surface with reflective characteristics.

	grout GROUT The material used to fill in the joints between stone tile. Grout can be cement or plastic resins.

	limestone LIMESTONE A sedimentary rock composed of calcium carbonate.

	Marble MARBLE: CHARACTERISTICS This standard includes general information on the characteristics and common uses of marble and identifies typical problems associated with the material. INTRODUCTION Marble is an extremely hard, metamorphic stone composed of calcite (CaCO3). It is formed as a result of the recrystallization of limestone under the intense pressure and heat of geologic processes. The effect of this process is the creation of a stone with a very tight crystalline structure and small but definite porosity. Because of its structure, marble can take a very high polish and is a very popular decorative stone for architectural and sculptural uses. The limited porosity of marble, especially polished marble, makes it less vulnerable to the leaching effects of water. Calcium carbonate, however, of which marble is composed, is highly susceptible to attack by acidic agents. Marble is readily dissolved by acids, even very dilute acids, however the actual results of acidic exposure will vary with the nature of the acid. Chlorides, nitrates, sulfates and other chemical compounds react differently with marble and produce various by-products, which have a wide range of solubility and impact on the durability of marble. For this reason, it is always important to determine the exact type of pollutants causing marble deterioration. Marble itself can be of two types, one composed of calcite and the other of dolomite. Dolomitic marble is much more resistant to acid attack than calcite marble. The color of marble ranges from the brilliant white of calcite to black, including blue-gray, red, yellow and green, depending upon the mineral composition. TYPICAL USES Marble has many decorative and structural uses. It is used for outdoor sculpture as well as for sculpture bases; in architecture it is used in exterior walls and veneers, flooring, decorative features, stairways and walkways. The way in which the stone is used may be a factor in limiting or controlling the severity of exposure. The use or function of the marble may also affect the feasibility of applying certain treatments, but type of use is not the primary factor in the major types of deterioration and damage to which marble is susceptible.